Rudy Arm to Spigot Mount to 15mm Ball-Loc Pivot Clamp


The Rudy Arm to Spigot Mount to 15mm Ball-Loc Pivot Clamp is the perfect solution to mount a monitor with your RF unit while having the comfort that it mounts to a baby pin on a cart or a c-stand.


Rudy Arm to Spigot Mount to 15mm Ball-Loc Pivot Clamp includes:

  • Rudy Arm – Single Arm System
    • 1x 20cm/8″ 15mm rod with captive o-rings
    • 1x Ball-loc clamp
    • 1x Friction-loc clamp
    • 2x universal mounting pins with 1/4-20″ and 3/8-16″ threads
    • O-Ring Kit
    • Total reach of 25cm/10″
    • Load Capacity of 9kg/20lb
    • Weight: 0.25kg/9.1 oz
  • Spigot Mount to 15mm Pivot Clamp
    • The Spigot Mount is a quick solution to mounting a 15mm set-up to a 5/8″ spigot.
    • It uses our Ball-loc system allowing for superior hold and heavier use.

The Rudy Arm system allows you to add or remove sections of the arm as needed and each component on the arm will fit any other 15mm system (always check load rating when re-configuring parts). The Rudy Arm is truly a professional transforming system, that can be adapted to almost any application on your camera and on set.

What makes the Rudy Arm Unique ?

  • Easy local control and single point locking mechanisms on pivot clamps
  • Horizontal and vertical adjustment support.
  • Quick lever adjustment gives you freedom of movement
Captive O-Ring Design
  • Rods are outfitted with small grooves that accept two O-ring sizes
  • Smaller friction o-rings allow for controlled clamp adjustment along the rod.
  • Larger captive o-rings keep the clamps and rod-ends captive when adjusting.

Universal Mounting Pin

  • 3 industry standard mounting options
  • 15mm mounting pin with male or female threads
  • Combination of 1/4-20″ and 3/8-16″ threads allow you to change thread size quickly
  • Cross holes help to wrench pin into place with a standard Hex-Key

Friction-Loc Pivot Clamps

  • Industry strong friction disks
  • Best used for fine adjustments
  • 360 degree position lock down

Ball-Loc Pivot Clamps

  • Rosette style ball-lock with heat treated ball bearings
  • Positive locking system that allows for adjust-ability
  • Superior strength because of inter-locking balls
  • Ball bearings are in-bedded in the locking surface and assured by our limited lifetime warranty

Solidly built with Anodized Aircraft Aluminum.


There are no reviews yet.

Be the first to review “Rudy Arm to Spigot Mount to 15mm Ball-Loc Pivot Clamp”

Your email address will not be published. Required fields are marked *