Arri 3/8″ Pin-Loc 19mm Pivot Clamp


The Arri 3/8″ Pin-Loc 19mm Pivot Clamp allows you to add an offset 19mm rod mount to your camera setup via any Arri 3/8″ Pin-Loc mounting pattern. Mount the clamp to any Arri style mounting point by tightening the screw with a 5/32 or 4mm Hex Key, which can be positioned at 90-degree increments. Make use of the positive Ball-Loc system to adjust the angle of the 19mm rod by 15 degree increments.

The Arri 3/8″ Pin-Loc 19mm Pivot Clamp increases your camera support mounting options, while allowing for adjustability.

Make use of our 19mm to 15mm Captive Step Down Bushing (available separately) to have the option to step down to 15mm rods.

SKU: 13315 Category: Tags: , , ,

3/8-16" thread is tightened by using a 4mm or 5/32" hex key.

Ball-Loc System
Our rosette style ball-lock is a positive locking system. Models coming with this system will have superior hold for heavier loads and long term use, on mobile carts or trucks. The locking system comes with heat treated ball bearings that are in-bedded in the locking surface and assured by our limited lifetime warranty. This system is best for when static and dynamic forces are at play.

Solidly built with Anodized Aircraft Aluminum.


There are no reviews yet.

Be the first to review “Arri 3/8″ Pin-Loc 19mm Pivot Clamp”

Your email address will not be published.